THRUST changes the judgment, not the bass level
When the whole mix ducks every time the kick arrives, ask what the detector is hearing loudly before lowering the ratio. In API’s design, THRUST is not a tone control that boosts bass in the audio path. It places a filter before the RMS detector and changes the weighting of energy across frequency, reducing the tendency of low frequencies to dominate the control signal. The kick can retain its size without being allowed to conduct the gain reduction of the entire mix on every hit.
A bypass comparison alone will not reveal the useful difference. Set attack and release in NORM, then compare MED and LOUD while readjusting threshold to keep the peak gain reduction similar. Listen not for more bass, but for whether the first vocal syllable after the kick, the snare backbeat, and the sustain of the bass remain in their intended places. THRUST is not automatically a punch switch. It reallocates which part of the rhythm the compressor treats as the event.
OLD and NEW are not two colours of the same setting
In the 2500+, OLD is a feedback topology: the detector receives its signal from the output after gain reduction. NEW is feed-forward, reading a split from the input. Because OLD listens again to a result that has already been reduced, its movement tends to moderate itself. NEW reads the incoming signal directly and applies the chosen ratio more explicitly. That signal position is why the manual describes OLD as smoother and more transparent, and NEW as more aggressive and obviously affected.
Remembering OLD as warmth and NEW as punch is too blunt for a session. If the first hit of a drum bus becomes flat in NEW, hear whether the direct topology is the issue or the attack is simply too short. If the low end sways loosely in OLD, decide whether that is musical breathing or a release that cannot recover before the next beat. Do not preserve the same threshold number when changing mode. Rematch the gain-reduction range and output level, then compare the envelope itself.
Choose stereo coupling separately from compression blend
One hundred percent stereo link can feel safe, but a tom or guitar attack on one side may pull the opposite channel down by the same amount, briefly disturbing the centre or narrowing the room. The 2500+ can vary the left/right control-voltage link from independent to fully linked and place filters only in that link circuit. The point is not to unlink the channels for artificial width. It is to decide which peaks deserve to become a shared event. A central kick and vocal should remain stable; a short percussion hit at the edge need not fold the entire image every time.
Use the current 2500+ Mix/Blend after that decision. X crossfades dry and compressed signals, while parallel mode leaves the dry signal in place and adds the compressed path. If MIX hides the compression from the start, errors in attack and release are harder to hear. Build a groove that does not overstate itself at 100 percent compressed, use link to settle image movement, and only then restore density with the blend. Parallel compression becomes a level of presence, not a rescue for an excessive setting.